Practical lab · Networks
IP subnet planner
Work out a subnet from its CIDR, count usable hosts and carve camera VLANs out of an address block.
Simulation — not real hardware
Simulation — not real hardware. Results are planning estimates from the formulas shown; real equipment, cabling and firmware differ. Check datasheets and site conditions before you buy or install.
What this lab covers
An IPv4 address with a prefix (CIDR notation, such as 192.168.10.0/24) says how many leading bits identify the network. The rest identify hosts. The first address is the network, the last is broadcast, and the ones between are usable — except a /31 (two addresses, used for point-to-point links per RFC 3021) and a /32 (one host).
Putting cameras on their own VLAN and subnet keeps their multicast and bulk video away from office traffic and lets a firewall decide who may reach them. Size each camera subnet for the cameras, a gateway and the recorder, plus room to grow (20 % here).
Worked example
192.168.10.0/24: mask 255.255.255.0, network 192.168.10.0, broadcast 192.168.10.255.
Usable 192.168.10.1 – 192.168.10.254 = 28 − 2 = 254 hosts.
48 cameras need (48 + 2) × 1.2 = 60 addresses, so a /26 (62 usable) is the smallest fit.
Try it
The block
- Network
- 10.20.0.0/22
- Subnet mask
- 255.255.252.0
- Wildcard
- 0.0.3.255
- Broadcast
- 10.20.3.255
- Usable range
- 10.20.0.1 – 10.20.3.254
- Usable hosts
- 1,022 of 1,024 addresses
Suggested camera VLANs
| VLAN | Group | Subnet | Gateway | Need / usable |
|---|---|---|---|---|
| 110 | Building A cameras (48) | 10.20.1.0/26 | 10.20.1.1 | 60 / 62 |
| 120 | Car park cameras (150) | 10.20.0.0/24 | 10.20.0.1 | 183 / 254 |
704 addresses left in the block for future VLANs. Largest subnets are placed first so each starts on its own boundary.
Talk to an engineer
Not sure which service fits?
Tell us what you are working on. A Foxnet engineer will point you to the right session, book or request — or tell you honestly if you do not need one.
