Practical lab · Surveillance

Camera bitrate & bandwidth

Estimate a camera stream from resolution, frame rate, codec and scene, then total it against an uplink.

Simulation — not real hardware

Simulation — not real hardware. Results are planning estimates from the formulas shown; real equipment, cabling and firmware differ. Check datasheets and site conditions before you buy or install.

What this lab covers

A camera's bitrate grows with pixels per second (width × height × frames per second) and with how much changes in the scene. This lab multiplies pixels per second by an average number of bits per pixel (0.04 / 0.064 / 0.1 for low, medium and high complexity with H.264) and applies about 55 % for H.265.

Use it to compare options and size uplinks, not to promise a figure: the camera's own bitrate setting, GOP length, smart-codec features and night-time noise change the real number. Keep a switch uplink below about 70 % so playback, exports and bursts have room.

Worked example

1080p at 25 fps, H.264, medium scene: 1920 × 1080 × 25 × 0.064 ≈ 3.3 Mbps.

The same in H.265: × 0.55 ≈ 1.8 Mbps. Twenty such H.264 cameras need about 66.4 Mbps — 66 % of a 100 Mbps uplink, so use gigabit.

Try it

Main stream
100, 1000 or 10000

89.5 Mbps

total for 24 cameras

Main stream
3.24 Mbps
Sub-stream
0.49 Mbps
Per camera
3.73 Mbps
Uplink use
9 %

Within the 70 % planning limit.

Progress is kept only in this browser.All labsNext: NVR storage sizing

Talk to an engineer

Not sure which service fits?

Tell us what you are working on. A Foxnet engineer will point you to the right session, book or request — or tell you honestly if you do not need one.