Practical lab · Surveillance

NVR storage sizing

Cameras × bitrate × hours × days, with RAID overhead, to size recorder disks.

Simulation — not real hardware

Simulation — not real hardware. Results are planning estimates from the formulas shown; real equipment, cabling and firmware differ. Check datasheets and site conditions before you buy or install.

What this lab covers

Recorder storage is bitrate × time. One megabit per second for an hour is 3,600 megabits = 450 MB, so each Mbps needs about 0.45 GB per hour. Multiply by cameras, recording hours per day and the days you must keep.

Motion or event recording stores only part of the day; enter the share you expect, but be cautious — busy scenes and night noise trigger more than you think. RAID protects against a failed disk at the cost of capacity: RAID 5 gives up one disk, RAID 6 two, RAID 1/10 half. Figures here are decimal terabytes, as drives are sold; the recorder may show less after formatting.

Worked example

16 cameras × 4 Mbps × 0.45 GB/h × 24 h × 30 days = 20,736 GB ≈ 20.7 TB.

With 10 % headroom: 22.8 TB. In RAID 5 with 8 TB disks that is 4 disks (24 TB usable).

Try it

From the bitrate lab or the recorder's statistics
100 for continuous
Disks

One disk of capacity for parity; survives one disk failure. Rebuilds of large disks are slow.

45.62 TB

to provision, including headroom

Video stored
41,472 GB
Per camera per day
43.2 GB
RAID 5 (single parity)
7 × 8 TB disks = 48 TB usable

Check how many bays the recorder has and the largest disk it supports. Surveillance-rated disks suit 24 × 7 writing.

Progress is kept only in this browser.All labsNext: CCTV network builder

Talk to an engineer

Not sure which service fits?

Tell us what you are working on. A Foxnet engineer will point you to the right session, book or request — or tell you honestly if you do not need one.