Practical lab · Networks

CCTV network builder

Place cameras, PoE switches and a recorder, connect them, and check each switch’s ports and PoE budget.

Simulation — not real hardware

Simulation — not real hardware. Results are planning estimates from the formulas shown; real equipment, cabling and firmware differ. Check datasheets and site conditions before you buy or install.

What this lab covers

Each PoE switch has two limits: the number of PoE ports and a total PoE power budget shared by all ports. Many switches reserve power by the class a camera announces (for example class 4 reserves 30 W) rather than by what it actually draws, so a design can fit by load and still be refused by class.

Drag devices on the drawing (or focus one and use the arrow keys), connect each camera to a switch in the table, and give every switch an uplink to the recorder. The checks update as you go. Real switches also have per-port limits, and long cable runs lose power.

Worked example

Eight class 3 cameras drawing 7 W each on an 8-port, 120 W switch: by load 8 × 7 = 56 W (fits), by class 8 × 15.4 = 123.2 W — over 120 W.

A switch that allocates by class would leave one camera dark. Use a larger budget, or configure the switch to allocate by actual consumption if it supports that.

Try it

NVR (recorder)SW1 · 120 W / 8 portsCAM1 · 7 WCAM2 · 7 WCAM3 · 7 WCAM4 · 7 W
Cameras and the switch each connects to
CameraClass / loadConnect toRemove
CAM13 / 7 W
CAM23 / 7 W
CAM33 / 7 W
CAM43 / 7 W

SW1 — 8 PoE ports, 120 W budget

Ports
4 of 8
By class
61.6 W (58.4 W spare)
By load
28 W (92 W spare)
Uplink
to NVR

Every camera has a port and every switch is within budget by class and by load.

Progress is kept only in this browser.All labsNext: Access-control door logic

Talk to an engineer

Not sure which service fits?

Tell us what you are working on. A Foxnet engineer will point you to the right session, book or request — or tell you honestly if you do not need one.